• Archives

  • Categories

  • Pages

When can I put my fountain back in my pond? | Ponds & Lakes Q&A

Q: When can I put my fountain back in my pond?

Q: When can I put my fountain back in my pond?

John – Pataskala, OH

A: Fountains do more than create an attractive splash in your pond or lake. They also allow for greater gas exchange at the water’s surface, expelling dangerous ammonia and drawing in healthy oxygen for your fish and other sub-surface critters.

When spring rolls around, it’s time to reinstall your fountain – but before you do, be sure to check your Farmer’s Almanac or with your meteorologist. Make sure there’s little chance of the pond icing over again.

Once you’re sure that temps will remain above freezing, perform some quick maintenance tasks before submerging the fountain and anchoring it into position, including:

  • Clean It Up: Pull out a power washer and spray down the motor so built-up material doesn’t trap heat.
  • Check the Cord: Inspect the power cord for cuts.
  • Make It Muskrat-Proof: Protect the cord with ratcord (power cord sleeve) if you have muskrats in your area.
  • Maintenance Visit: Send the motor in for regular seal and oil maintenance if you haven’t done so in a few years.

When you put your fountain back into place, make sure the mooring lines are snug enough to keep it secure. When anchoring with blocks at the bottom of the pond, make sure the lines are spread far enough apart so the fountain doesn’t spin from the force of the motor, which could cause the lines to get tangled.

As soon as you’ve put your fountain back in place, add your first dose of Pond Dye to the water so the spraying action will disperse the color evenly. Nature’s Blue™ or Black DyeMond™ will shade the water, minimize algae blooms and give your landscape a natural-looking pop of color

Pond Talk: What’s your fountain’s favorite spray pattern?

Convenient Water-Soluble Packets - Pond Logic(r) Pond Dye Packets

When should I remove my fountain? | Ponds & Lakes Q&A

Q: When should I remove my fountain?

Q: When should I remove my fountain?

Ray – McDermott, OH

A: Among your fall-preparation chores is removing the fountain and storing it for winter, particularly if you live in an area that endures freezing temperatures. Why? When ice forms, the cold stuff might damage the float. Or it could create a barrier that prevents water from passing through the spray nozzle, causing your fountain run dry and destroying your motor.

Your best bet: Remove the fountain before the ice begins to form. Sure, you could wait until a thin layer develops and then remove it—but that means you have to get wet and messy when it’s freezing. Not fun. Get a jump-start now before temperatures get too frigid.

Here are four easy steps to pulling out and storing your fountain for the winter:

  • Pull the Plug: Turn off the power to the fountain and pull it ashore. Most units have a quick disconnect at the motor that allows you separate the fountain from the main power cord.
  • Scrub Down: Wash down the fountain and float assembly to remove any algae or debris that has accumulated over the season. If you have a pressure washer, use it. It’ll make short work of even the dirtiest fountain.
  • Electrical Check: Inspect wiring and electrical cables for signs of wear or damage. If your fountain has lights, check for burned out or damaged bulbs and lenses.
  • Safe Storage: Once your fountain is cleaned and inspected, store it in an upright position in a climate-controlled location, like a heated pole barn or garage, until spring.

Now that it’s out and cleaned, you might want to consider sending your fountain to a licensed repair facility for routine maintenance tasks, including oil changes and/or seal replacements. Be sure to read through your user’s manual for special instructions and maintenance plans to keep your fountain running at its very best.

If you don’t plan on using the pond for ice skating or other winter recreation, now is a great time to install an Airmax® Aeration System to keep your pond oxygenated and healthy through the winter months. The aerator will circulate the water while keeping a hole in the ice surface, which will bring oxygen in and allow toxic gases to escape.

Pond Talk: How often do you have your fountain serviced by a licensed repair facility?

Aerate Your Pond in All Seasons - Airmax® Pond Series™ Aeration

Can I Leave My Fountain Running During the Winter? – Pond & Lake Q & A

Picture of Fountain Running in Winter.

Q: I have a decorative fountain in my pond. Can I leave it running for the Winter? – Andy of Minnesota

A: No. Just look at the picture to the left. Although it may look neat, the consequences are great. If you left your fountain running during the Winter, the ice, over time, will freeze around
it. This can cause severe damage to the fountain. The prop could freeze and burn the motor out or the float could crack causing the fountain to sink to the bottom!

Removing the fountain: Remove and store the fountain in a cool, dry place. This is also a great time to scrub and clean the fountain. Remove any debris or algae from anywhere around the prop. Once squeaky clean, store until the Spring.

Follow

Get every new post delivered to your Inbox.

Join 142 other followers